定制家具中典型板材VOCs的溯源及排放特征分析

Abstract
Figure/Table
References
Related Citation (15)

Download: PDF (622 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract The composition, concentration and emission law of VOCs from five typical customized furniture plates were explored by using a 1m³ small environmental chamber under certain conditions. The results showed that 54 target compounds were identified from the five plates, and the main components were OVOCs and alkanes, accounted for 71.37%~85.77% and 11.79%~24.84%, respectively. The TVOCs concentration of different plates were quite different. The TVOCs concentration of veneer -medium density fiberboard(MDF) was as high as 836.49μg/m³, which was much higher than other boards, while it was the lowest in solid wood ecological board, which was the most environmentally friendly. The emission concentrations of VOCs from five kinds of boards were measured hourly. It was found that the relative emission concentrations of formaldehyde were as follows: veneer MDF > moisture-proof board > veneer particle board > solid wood ecological board > PVC blister board; the emission concentration of TVOCs (except formaldehyde) was as follows: veneer particle board > veneer MDF > PVC blister board > moisture-proof board > solid wood ecological board. In these five plates, formaldehyde, n-hexane and ethyl acetate were the main substances, and the concentration contribution of formaldehyde accounts for 40.44%~82.59% of TVOC. At the same time, based on VOCs emission characteristics from five kinds of plates, the traceability analysis of various compounds is helpful for the source control of VOCs pollution.

Key words： furniture plates volatile organic compounds (VOCs) component and characteristics source analysis emission concentration

Received: 20 December 2021

PACS:

X502

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	TIAN Jiao
	QIN Ye-xia
	YANG Shuai-jun
	Lü Ye-tong
	HUANG Hao-min
	YE Dai-qi

Cite this article:

TIAN Jiao,QIN Ye-xia,YANG Shuai-jun等. Traceability and emission characteristics analysis of VOCs from typical plates in customized furniture[J]. CHINA ENVIRONMENTAL SCIENCECE, 2022, 42(7): 3058-3067.

URL:

http://www.zghjkx.com.cn/EN/ OR http://www.zghjkx.com.cn/EN/Y2022/V42/I7/3058

[1]	Klepeis N E, Nelson W C, Ott W R, et al. The National Human Activity Pattern Survey (NHAPS):A resource for assessing exposure to environmental pollutants[J]. J. Expo. Anal. Environ. Epidemiol., 2000,11(3):231-252.
[2]	Sahlberg B, Gunnbjörnsdottir M, Soon A, et al. Airborne molds and bacteria, microbial volatile organic compounds (MVOC), plasticizers and formaldehyde in dwellings in three North European cities in relation to sick building syndrome (SBS)[J]. Science of the Total Environment, 2013,444:433-440.
[3]	Spengler J, Sexton K. Indoor air pollution:A public health perspective[J]. Science, 1983,221(4605):9-17.
[4]	Wolkoff P, Nielsen G D. Non-cancer effects of formaldehyde and relevance for setting an indoor air guideline[J]. Environment International, 2010,36(7):788-799.
[5]	Duong A, Steinmaus C, Mchale C M, et al. Reproductive and developmental toxicity of formaldehyde:A systematic review[J]. Mutation Research-Reviews in Mutation Research, 2011,728(3):118-138.
[6]	Tang X-Q, Ren Y-K, Chen R-Q, et al. Formaldehyde induces neurotoxicity to PC12 cells involving inhibition of paraoxonase-1expression and activity[J]. Clinical&Experimental Pharmacology&Physiology, 2011,38(4):208-214.
[7]	Vargová M, Wagnerová J, Lišková A, et al. Subacute immunotoxicity study of formaldehyde in male rats[J]. Drug and Chemical Toxicology, 1993,16(3):255-275.
[8]	Hatfield M L, Huff Hartz K E. Secondary organic aerosol from biogenic volatile organic compound mixtures[J]. Atmospheric Environment, 2011,45(13):2211-2219.
[9]	Harb P, Locoge N, Thevenet F. Emissions and treatment of VOCs emitted from wood-based construction materials:Impact on indoor air quality[J]. Chemical Engineering Journal, 2018,354:641-652.
[10]	Jian K, Liu J, Pei J. The indoor volatile organic compound (VOC) characteristics and source identification in a new university campus in Tianjin, China[J]. Journal of the Air&Waste Management Association (1995), 2017,67(6):725-737.
[11]	张瑞艳,王莹,索也兵.木家具中甲醛及挥发性有机物检测方法分析[J].家具, 2019,40(6):108-111. Zhang R Y, Wang Y, Suo Y B. Analysis of detection methods of formaldehyde and volatile organic compounds in wood furniture[J]. Furniture, 2019,40(6):108-111.
[12]	Guo H, Murray F, Lee S C, et al. Evaluation of emissions of total volatile organic compounds from carpets in an environmental chamber[J]. Building and Environment, 2004,39(2):179-187.
[13]	Fechter J-O, Englund F, Lundin A. Association between temperature, relative humidity and concentration of volatile organic compounds from wooden furniture in a model room[J]. Wood Material Science and Engineering, 2006,1(2):69-75.
[14]	Xiong J Y, Chen F Q, Sun L H, et al. Characterization of VOC emissions from composite wood furniture:Parameter determination and simplified model[J]. Building and Environment, 2019,161:106237.
[15]	杨叶,李立清,马卫武,等.相对湿度、温度对胶合板甲醛释放的影响[J].中国环境科学, 2016,36(2):390-397. Yang Y, Li L Q, Ma W W, et al. Effects of relative humidity and temperature on formaldehyde emission from plywood[J]. China Environmental Science, 2016,36(2):390-397.
[16]	Xiong J Y, Liu C, Zhang Y P. A general analytical model for formaldehyde and VOC emission/sorption in single-layer building materials and its application in determining the characteristic parameters[J]. Atmospheric Environment, 2012,47:288-294.
[17]	Wang Y Z, Yang T, He Z C, et al. A general regression method for accurately determining the key parameters of VOC emissions from building materials/furniture in a ventilated chamber[J]. Atmospheric Environment, 2020,231:117527.
[18]	Xiong J Y, Yao Y, Zhang Y P. C-history method:rapid measurement of the initial emittable concentration, diffusion and partition coefficients for formaldehyde and VOCs in building materials[J]. Environmental Science&Technology, 2011,45(8):3584-3590.
[19]	Ho D X, Kim K H, Sohn J R, et al. Emission rates of volatile organic compounds released from newly produced household furniture products using a large-scale chamber testing method[J]. Scientific World Journal, 2011,11:1597-1622.
[20]	GB 18580-2017室内装饰装修材料人造板及其制品中甲醛释放限量[S]. GB 18580-2017 Indoor decorating and refurbishing materials-Limit of formaldehyde emission of wood-based panel and finishing products[S].
[21]	ASTM D6007-02小型环境箱测定木制品释放气体中甲醛浓度的标准测试方法[S]. ASTM D6007-02 Standard test method for determining formaldehyde concentration in air from wood products using a small scale chamber[S].
[22]	EN 717-1:2004木基板-甲醛释放的测定[S]. EN 717-1:2004 Wood-based panel-Determination of formaldehyde release[S].
[23]	ANSI/BIFMA M7.1-2007测定从办公家具、部件和座椅中排放出的挥发性化合物(VOC)的标准试验方法[S]. ANSI/BIFMA M7.1-2007 Standard test method for determining VOC emissions from office furniture, components and Seating[S].
[24]	GBT 31107-2014家具中挥发性有机化合物检测用气候舱通用技术条件[S]. GBT 31107-2014 Environmental chamber for the determination of volatile organic compounds of furniture-General technical requirements[S].
[25]	HJ 683-2014环境空气醛、酮类化合物的测定高效液相色谱法[S]. HJ 683-2014 Ambient air-Determination of aldehyde and ketone compounds-High performance liquid chromatography[S].
[26]	HJ 734-2014固定污染源废气挥发性有机物的测定固相吸附-热脱附/气相色谱-质谱法[S]. HJ 734-2014 Stationary source emission-Determination of volatile organic compounds-Sorbent adsorption and thermal desorption gas chromatography mass spectrometry method[S].
[27]	李赵相,王冬梅,张希.室内环境测试舱性能指标及测试方法的探讨[C]//见:2016年中国非金属矿科技与市场交流大会//中国安徽合肥:[出版者不详], 2016. 48-52. Li Z X, Wang D M, Zhang X. The research of performance indicators and testing methods in the indoor environmental chamber[C]//see:2016 China nonmetallic mining technology and market exchange conference//Hefei, Anhui, China:[publisher unknown], 2016:48-52.
[28]	He Z K, Zhang Y P, Wei W J. Formaldehyde and VOC emissions at different manufacturing stages of wood-based panels[J]. Building and Environment, 2012,47:197-204.
[29]	Adamova T, Hradecky J, Panek M. Volatile organic compounds (VOCs) from wood and wood-based panels:Methods for evaluation, potential health risks, and mitigation[J]. Polymers (Basel), 2020, 12(10):2289.
[30]	杜超.纤维板和刨花板VOC快速检测研究[D].哈尔滨:东北林业大学, 2015. Du C. Study on rapid VOC detection of fiberboard and particleboard[D]. Harbin:Northeast Forestry University, 2015.
[31]	李世杰,殷宝辉,赵雪艳,等.家具板材排放VOCs成分谱及排放因子研究[J].环境科学研究, 2020,33(4):859-867. Li S J, Yin B H, Zhao X Y, et al. Composition and emission factors of VOCs released from wood-based panels[J]. Research of Environmental Sciences, 2020,33(4):859-867.
[32]	陈峰.饰面刨花板挥发性有机化合物释放特性及影响因子的研究[D].哈尔滨:东北林业大学, 2010. Chen F. Study on the release characteristics and influence factors of volatile organic compounds emission from surface finishing particleboard[D]. Harbin:Northeast Forestry University, 2010.
[33]	沈隽,李爽,类成帅.小型环境舱法检测中纤板挥发性有机化合物的研究[J].木材工业, 2012,26(3):15-18. Shen J, Li S, Lei C S. Volatile organic compound emission from medium density fiberboard tested in a small environmental chamber[J]. China Wood Industry, 2012,26(3):15-18.
[34]	Kim S, Kim J-A, Kim H-J, et al. Determination of formaldehyde and TVOC emission factor from wood-based composites by small chamber method[J]. Polymer Testing, 2006,25(5):605-614.
[35]	王启繁,沈隽,蒋利群,等.三聚氰胺贴面刨花板对环境影响的综合评价[J].中南林业科技大学学报, 2019,39(3):99-106. Wang Q F, Shen J, Jiang L Q, et al. Comprehensive evaluation on impact of melamine veneer particleboard on indoor environment[J]. Journal of Central South University of Forestry&Technology, 2019,39(3):99-106.
[36]	Kozicki M, Guzik K. Comparison of VOC emissions produced by different types of adhesives based on test chambers[J]. Materials, 2021,14(8):1924.
[37]	Jiang C J, Li D D, Zhang P Y, et al. Formaldehyde and volatile organic compound (VOC) emissions from particleboard:Identification of odorous compounds and effects of heat treatment[J]. Building and Environment, 2017,117:118-126.
[38]	兰拓.马尾松木材干燥过程中有机挥发物释放的研究[D].北京:北京林业大学, 2007. Lan T, Study on VOC emission from the wood drying of pinus massoniana[D]. Beijing:Beijing Forestry University, 2007.
[39]	黄山,周培国,卢志刚,等.松木、杨木纤维干燥排气总挥发性有机物与醛酮的排放特征[J].木材工业, 2012,26(6):17-21. Huang S, Zhou P G, Lu Z G, et al. Analysis of chemical emission from a medium density fiberboard plant[J]. China Wood Industry, 2012, 26(6):17-21.
[40]	Lubis M A R, Park B-D, Lee S-M. Modification of ureaformaldehyde resin adhesives with blocked isocyanates using sodium bisulfite[J]. International Journal of Adhesion and Adhesives, 2017,73:118-124.
[41]	Yadav S M, Lubis M A R, Wibowo E S, et al. Effects of nanoclay modification with transition metal ion on the performance of urea-formaldehyde resin adhesives[J]. Polymer Bulletin, 2021,78(5):2375-2388.