Pyrolysis of rolling oil sludge and its kinetic analysis
LU Wen-tao1, HE Pin-jing1,2, SHAO Li-ming1,2, ZHANG Hua1
1. Institute of Waste Treatment & Reclamation, Tongji University, Shanghai 200092, China;
2. Centre for the Technology Research and Training on Household Waste in Small Towns & Rural Area, Ministry of Housing and Urban-Rural Development, Shanghai 200092, China
The pyrolysis behavior of a cold rolling oil sludge was studied using thermogravimetric analysis. Combined with the results from elemental analysis, X-ray diffraction spectrometry and X-ray fluorescence spectrometry, the thermochemical conversion reactions and kinetic characteristics during the pyrolysis were identified. The result showed that the oil fraction evaporated firstly and then came with thermal decomposition reactions in the temperature range of 174~447℃. Between 652 to 863℃, metal oxides in the sludge were reduced by the pyrolytic char. Kinetic analysis of the oil thermal conversion was performed using isoconversional method and the curve of apparent activation energy versus conversion was obtained. It was shown that the apparent activation energy kept increasing with the thermal conversion process. And the point of a=0.6 was obviously a boundary to divide the whole process into two stages, i.e. evaporation and pyrolysis. The existence of residue was able to decrease the apparent activation energy during oil evaporation via comparing the curves of the extracted oil and rolling oil sludge.
鲁文涛, 何品晶, 邵立明, 章骅. 轧钢含油污泥的热解与动力学分析[J]. 中国环境科学, 2017, 37(3): 1024-1030.
LU Wen-tao, HE Pin-jing, SHAO Li-ming, ZHANG Hua. Pyrolysis of rolling oil sludge and its kinetic analysis. CHINA ENVIRONMENTAL SCIENCECE, 2017, 37(3): 1024-1030.
Biswal B K, Tiwari S N, Mukherji S. Biodegradation of oil in oily sludges from steel mills [J]. Bioresource Technology, 2009,100(4): 1700-1703.
[2]
环境保护部令第39号.国家危险废物名录 [Z]. 2016-06-14.
[3]
Liu B, Zhang S-G, Tian J-J, et al. Recycle of valuable products from oily cold rolling mill sludge [J]. International Journal of Minerals Metallurgy and Materials, 2013,20(10):941-946.
[4]
Qin L, Han J, He X, et al. Recovery of energy and iron from oily sludge pyrolysis in a fluidized bed reactor [J]. Journal of Environmental Management, 2015,154:177-182.
[5]
Hu G, Li J, Hou H. A combination of solvent extraction and freeze thaw for oil recovery from petroleum refinery wastewater treatment pond sludge [J]. Journal of Hazardous Materials, 2015, 283:832-840.
[6]
Liu B, Zang S-G, Tian J-J, et al. Strontium ferrite powders prepared from oily cold rolling mill sludge by solid-state reaction method [J]. Rare Metals, 2013,32(5):518-523.
[7]
Zhang J, Li J, Thring RW, et al. Oil recovery from refinery oily sludge via ultrasound and freeze/thaw [J]. Journal of Hazardous Materials, 2012,203:195-203.
[8]
Zhou L, Jiang X, Liu J. Characteristics of oily sludge combustion in circulating fluidized beds [J]. Journal of Hazardous Materials, 2009,170(1):175-179.
[9]
Liu J, Jiang X, Zhou L, et al. Pyrolysis treatment of oil sludge and model-free kinetics analysis [J]. Journal of Hazardous Materials, 2009,161(2/3):1208-1215.
Hu G, Li J, Zeng G. Recent development in the treatment of oily sludge from petroleum industry: A review [J]. Journal of Hazardous Materials, 2013,261:470-490.
[12]
Lopez-Gonzalez D, Fernandez-Lopez M, Valverde J L, et al. Kinetic analysis and thermal characterization of the microalgae combustion process by thermal analysis coupled to mass spectrometry [J]. Applied Energy, 2014,114:227-237.
[13]
Shie J L, Chang C Y, Lin J P, et al. Resources recovery of oil sludge by pyrolysis: kinetics study [J]. Journal of Chemical Technology and Biotechnology, 2000,75(6):443-450.
[14]
Song W, Liu J, Nie Y. Pyrolysis behaviors of oil sludge based on TG/FTIR and PY-GC/MS [J]. Frontiers of Environmental Science & Engineering in China, 2010,4(1):59-64.
[15]
Kök M V, Acar C. Kinetics of crude oil combustion [J]. Journal of Thermal Analysis and Calorimetry, 2006,83(2):445-449.
[16]
López-González D, Fernandez-Lopez M, Valverde J L, et al. Kinetic analysis and thermal characterization of the microalgae combustion process by thermal analysis coupled to mass spectrometry [J]. Applied Energy, 2014,114:227-237.
[17]
Wu R M, Lee D J, Chang C Y, et al. Fitting T G A data of oil sludge pyrolysis and oxidation by applying a model free approximation of the Arrhenius parameters [J]. Journal of Analytical and Applied Pyrolysis, 2006,76(1/2):132-137.
[18]
Ozgen O, Kok M V. Pyrolysis analysis of crude oils and their fractions [J]. Energy & Fuels, 1997,11(2):385-391.
[19]
Sfakiotakis S, Vamvuka D. Development of a modified independent parallel reactions kinetic model and comparison with the distributed activation energy model for the pyrolysis of a wide variety of biomass fuels [J]. Bioresource Technology, 2015,197: 434-442.
[20]
Barneto A G, Molto J, Ariza J, et al. Thermogravimetric monitoring of oil refinery sludge [J]. Journal of Analytical and Applied Pyrolysis, 2014,105:8-13.
[21]
Korda A, Santas P, Tenente A, et al. Petroleum hydrocarbon bioremediation: sampling and analytical techniques, in situ treatments and commercial microorganisms currently used [J]. Applied Microbiology and Biotechnology, 1997,48(6):677-686.
[22]
Vyazovkin S, Sbirrazzuoli N. Isoconversional kinetic analysis of thermally stimulated processes in polymers [J]. Macromolecular Rapid Communications, 2006,27(18):1515-1532.
[23]
Lin J P, Chang C Y, Wu C H, et al. Thermal degradation kinetics of polybutadiene rubber [J]. Polymer Degradation and Stability, 1996,53(3):295-300.
[24]
Wu R M, Chu C P, Lee D J, et al. Modeling sludge as continuous mixture during thermal pyrolysis [J]. Journal of the Chinese Institute of Chemical Engineers, 2003,34(5):587-593.
[25]
Saha B, Ghoshal A K. Model-free kinetics analysis of waste P E sample [J]. Thermochimica Acta, 2006,451(1/2):27-33.
[26]
Qin H, Yue Y, Zhang L, et al. Study on Co-combustion Kinetics of Oil Shale Sludge and Semicoke [J]. Energy & Fuels, 2016, 30(3):2373-2384.
[27]
Kök M V, Karacan O. Pyrolysis Analysis and Kinetics of Crude Oils [J]. Journal of Thermal Analysis and Calorimetry, 52(3):781-788.
[28]
Punnaruttanakun P, Meeyoo V, Kalambaheti C, et al. Pyrolysis of API separator sludge [J]. Journal of Analytical and Applied Pyrolysis, 2003,68-9:547-560.
[29]
Aboulkas A, El Harfi K, El Bouadili A. Pyrolysis of olive residue/low density polyethylene mixture: Part I Thermogravimetric kinetics [J]. Journal of Fuel Chemistry and Technology, 2008, 36(6):672-678.
[30]
Pilawka R, Paszkiewicz S, Rosaniec Z. Thermal degradation kinetics of PET/SWCNTs nanocomposites prepared by the in situ polymerization [J]. Journal of Thermal Analysis and Calorimetry, 2014,115(1):451-460.
[31]
Rajeshwari P. Kinetic analysis of the non-isothermal degradation of high-density polyethylene filled with multi-wall carbon nanotubes [J]. Journal of Thermal Analysis and Calorimetry, 2016,123(2):1523-1544.
[32]
Vyazovkin S. An approach to the solution of the inverse kinetic problem in the case of complex processes [J]. Thermochimica Acta, 1993,223:201-206.
